Substantial posts by TheFrenchVoice, who started the thread, and by the forum’s most active contributors. 13 of 29 posts are listed.
Page 1
TheFrenchVoice, 15 July 2011Hello everyone. Well here we are, almost 2 years later. I hope you've all kept well. After building a temporary booth, we have started building the final studio. Again I…
TheFrenchVoice, 26 July 2011Hi Brian, thanks for your reply - the bottom coat will be attached to the plywood with screws going through small battens then 705 then ply, the top coat will be just…
TheFrenchVoice, 3 August 2011Sorry for delay in reply work and visiting family kept me away from building... Brian thanks for that - in my case as ceiling and floor are parallel I need to break this…
Soundman2020, 4 August 2011Just curious, but why do you have the room (CR) oriented that way? Would it not be better to follow the more common method, and have the speakers firing down the long…
TheFrenchVoice, 5 August 2011Thanks Brian and Stuart for your concern but to reiterate, what I have posted about so far (plan, photos and question) is about an ISO booth - vocal and instruments. At…
xSpace, 11 August 2011Sir, it is Brien...not Brian or Bryan or any other configuration. An overhead anything, really, should be mounted hard to the upper surface. Now I have no idea what a…
TheFrenchVoice, 12 August 2011Right, BriEn it is then, apologies for that! Answer my question it does indeed, ta very much! I was (obviously wrongly) always under the impression that clouds were…
xSpace, 13 August 2011You could use wire but the hardware required brings in more moving parts that could, over time, weaken the eyelets in either the joist above or the cloud frame below, to…
TheFrenchVoice, 13 August 2011What you're saying makes sense Brien, especially as it allows for adjustements in the angle of the clouds. Again, thank you very much for the time you take to help out -…
TheFrenchVoice, 21 August 2011By the way Glenn, I think that when you posted the above you were under the impression that the plan was one of a CR. As it is an ISO booth would you still go for what…
TheFrenchVoice, 22 August 2011And while I'm at it in the questions department... Do you guys think I'd be better of with the big superchunk on the top right of the plan as in version 1 or with a…
TheFrenchVoice, 25 August 2011Door frame finally done - was a right pain in the arse to do but looks superb (done in american walnut veneered mdf), drywall going up, feels like I'm eating acoustic…
TheFrenchVoice, 28 August 2011If anyone at all knows about big superchunk re. smaller superchunk plus hangers please let me know - I'm now ready to put them on and could do with a knowledgeable…