Page 1 of 1
Hebel Bricks
Posted: Fri Jul 25, 2003 7:53 pm
by Al
Anyone have any experience using Hebel products?
If I were to build a room in a room, would these serve as good way to construct the outer wall of the inner room? Or how 'bout the walls between the control room and the studio?
Check out
www.hebelaustralia.com.au for more products.
Thanks
Al
Re: Hebel Bricks
Posted: Sun Jul 27, 2003 11:06 am
by Sen
Al wrote:Anyone have any experience using Hebel products?
If I were to build a room in a room, would these serve as good way to construct the outer wall of the inner room? Or how 'bout the walls between the control room and the studio?
Check out
www.hebelaustralia.com.au for more products.
Thanks
Al
Al,
I think any brick will do as long as they're not damaged too much so that you can't lay 'em properly. I would recommend using the cheapest you can find. I looked at the link, but wasn't able to find any pictures of the bricks. If you don't care about the colour and don't have to match your studio esthetically with anything else, just use second hand bricks...you'll save at least half the money.
The wall between CR and studio would probably be better if it was the stud/plaster construction.
hope it helps a little..
Posted: Sun Jul 27, 2003 5:59 pm
by knightfly
Sen, from what I saw on the site it looks like they sell more like hollow concrete blocks and some specialty stuff, not "real" bricks...
Al, I've no experience with the particular product but the 75PP wall construction looks to be a good isolation wall.
I downloaded several of their PDF's - between CR and tracking room it (the 75PP) should do quite well, with an STC rating of 64 - It would also allow independent bedding of double glass windows, although you'd need to use pretty good glass to minimise degradation of the STC at the window.
Now, if they don't want 10 times what you could build it for in regular materials, you should be good.
On the other hand, Sen has a good point in that double-framed walls with double wallboard on the outer sides of each are effectuve and reasonably priced... Steve
Posted: Mon Jul 28, 2003 2:28 am
by Michael Jones
Bricks are cheap. Less than a buck (US) a square foot.
Getting them put up is where you run into the money. It cost me around $3.50/sq.ft.
So it cost me around $4500 to "brick" my studio.
Worth it in my book, but a significant cost to consider.