I had a look at new Blue Bear u/date..

Sen · Post by **Sen** » Fri Apr 25, 2003 6:18 pm

....and it's looking really good. John, I believe it's designed by you!(?)
I was just wandering how the wall in the control room picture (the wall with slats on the left side looking towards the back of the Control room) was constructed? What is behind it (just air gap and outer wall) and are the slats attached directly onto the stud frame?

It's a great looking project.....thanks for updating the pics John....

Post by **John Sayers** » Sat Apr 26, 2003 10:22 am

Check out the plan Sen - it's on the first BlueBear page.

cheers
john

Sen · Post by **Sen** » Sun Apr 27, 2003 10:40 pm

Cool, I had a look at the plans..Eventhough the drawings are really small, I think I sort of figured out how it was done.
If I've interpreted the plan correctly, the slat resonator section of the walls was done like this: (from outside to inside)
Outer wall >>>insulation between studs>>>plaster>>>air gap>>>studs with insulation (angled frame)>>>>slat finish
Is that it?

And what was the finish in the other part of the CR? Plaster?

Thanks

Post by **John Sayers** » Mon Apr 28, 2003 9:21 am

yes that's it - the rest is plaster but will have a layer of insulation on it as well.

cheers
john

Sen · Post by **Sen** » Mon Apr 28, 2003 6:58 pm

Cool..Thanks John,
I just wanted to make sure, coz I think you suggested something like that to me a while ago, so I wanted to double check that I ,sort of, understood the concept.

cheers