Page 1 of 1
solderless wall plates? good or no good?
Posted: Fri Feb 13, 2015 3:20 pm
by Mike808
Looking into purchasing solderless wall plates for my studio. I was wondering if anyone has had any problems with them and is there a difference between the wall plates you solder? Thank you Also does anyone have any ideas for alternatives to using wall plates.
Re: solderless wall plates? good or no good?
Posted: Tue Mar 03, 2015 11:51 am
by Johnnie
well, it doesn't look as clean, but there's always the snake option. I've seen several studios that went that route rather than using a wall plate. Just ran a snake through the wall between the control room and the studio (with a 90 degree bend and insulation stuffed in and with PVC tubing as close to the size of the snake as possible) then simply plugging into the snake rather than a wall plate.
Re: solderless wall plates? good or no good?
Posted: Tue Mar 03, 2015 12:11 pm
by Mike808
Thank you very much i did pick up a 16x8 snake for the live room and a 8x4 snake for the iso booth. I ran 2 inch pvc pipe thru the walls at an angle and will be stuffing them with insulation.
Re: solderless wall plates? good or no good?
Posted: Thu Apr 09, 2015 3:26 pm
by Parker1
[SPAM DELETED BY MODERATOR]
Re: solderless wall plates? good or no good?
Posted: Fri Apr 24, 2015 10:52 pm
by Parker1
Parker1 wrote:[SPAM DELETED BY MODERATOR]
[SPAM DELETED BY MODERATOR - AGAIN!]
[MODERATOR SAYS: BOOM! That was the second shoe I needed. BYE BYE!]