Page 1 of 1
Knightfly, your post is confusing me!
Posted: Mon Dec 01, 2003 2:06 am
by Michael Jones
The diagram located here:
http://www.johnlsayers.com/phpBB2/viewt ... 8&start=45
seems to show that the 2 studs are actually touching each other.
Isn't that a bad thing?
What's wrong with doing it like this:
Posted: Mon Dec 01, 2003 2:07 am
by Michael Jones
And a view from the other side:
Notice that the staggered stud, exterior wall has no studs that touch the flanking interior wall.
Posted: Mon Dec 01, 2003 9:02 am
by giles117
Hey Mike, I'd reverse your wall materials layouts making sure you seal those ends with acoustical sealant (the opposing wall materials.)
Bryan Giles
Posted: Mon Dec 01, 2003 10:22 am
by knightfly
Michael, good catch - I originally started out to draw that WITHOUT the left, wood framed wall - the horizontal 2x4 was just going to be an anchor for the rubber-surrounded sway brace that holds the right, steel stud frame in place without hard contact.
In my drawing, though, this is showing a CEILING with two walls coming up to it. Still, there is a flanking path thru the solid wood wall frame's cap and into the ceiling joists. I'll re-do that as soon as I can, thank you -
Your proposed layout is fine as far as framing goes, but you'll get better corners if you bring one panel in from the left, leave 1/4" gap, caulk, then one panel in from the right, 1/4" gap, caulk, and alternate til you're done - this gives more caulk beads and a much more tortuous path for sound leaks, without any hard contact between intersecting wall panels.
I'll notate that drawing that confused you, until I can replace it with a better one. Again, thanks for catching that... Steve
Posted: Mon Dec 01, 2003 12:20 pm
by Michael Jones
Point taken guys.
I just threw the material up there for the photo.
The actual method of installation will be like you're saying.
Posted: Thu Dec 04, 2003 6:10 am
by knightfly
Michael, I redrew the drawing in question - see what you think... Steve