The Amp Take off the PA System Experience.

Niccie · Post by **Niccie** » Wed Jun 07, 2006 12:59 am

Well i finally did it, i took off the electronic parts out of the box of my power amplified monitors.
Wasn't that hard, and get the Phase 1 ready in about 2 1/2 hours, of continuous work.Here the pics with a short description.

PHASE 1.

Niccie · Post by **Niccie** » Wed Jun 07, 2006 1:10 am

This is the begining, i made a mistake in the uploading order. Sorry.

Niccie · Post by **Niccie** » Wed Jun 07, 2006 1:15 am

Soldering ... to the new terminal, and a view of it.

knightfly · Post by **knightfly** » Tue Jun 20, 2006 12:57 pm

Can't tell from the pix; were those speakers bi-amped, and did you set up two pairs of terminals per box in order to maintain the biamping capability? Steve

Niccie · Post by **Niccie** » Wed Jun 28, 2006 9:26 am

Hello Steve, this speakers are not bi amped, they have some sort of passive cross over inside the boxes, i just took off the amp from the right speaker box and then i sealed the box to avoid any possible air escape out of it.

Dave-H · Post by **Dave-H** » Thu Jul 20, 2006 6:41 am

And now the internal volume of the speaker is wrong??

Niccie · Post by **Niccie** » Mon Jul 31, 2006 10:09 am

not even close to be wrong, because the other box is exactly the same way but this one didnt came with any amp built in, so nothing goes wrong with what i did, all you have to take care is to make the hole closing sealed and that's all.

As i say b4 sound is just great as it ever was.

I really dont know why ppl have that mith fear based abou all this, just read some good books about phisics and acoustics, and it's all there, noyhing to be scared of, it's all doable but u need to know what u're doing of course.

Well i'm taking off internet at home, so i will be no more around.
Thnk you all guys best regards.

Bye