Interpreting 2D Wall calculator results

dnafe · Post by **dnafe** » Fri Mar 04, 2005 11:10 pm

Hi All

Just ran an updated set of numbers into the program and end up with this graph...as you can see things get slightly weird below 200 hz...is there anything to be really concerned about as we're only talking a dippsy-doodle of 1-2 db until the Hz rolls off?

Don

dnafe · Post by **dnafe** » Fri Mar 04, 2005 11:36 pm

Room is 19'10" X 10'6" X 8'

I used the coefficient numbers for RXL 40 (3") from Bob Gold's table.

This is not entirely accurate as the RXL 40 panels will only be covering 24 sq ft on the front wall and 16 sq ft on the side wall at the first mirror point. There will also be floor to ceiling 2 - RXL 40 panels stacked vertically in each of the four corners of the room.

Hope this added info helps

Don

AVare · Post by **AVare** » Sun Mar 06, 2005 6:43 am

...is there anything to be really concerned about as we're only talking a dippsy-doodle of 1-2 db until the Hz rolls off?

No.

Succinctly;
Andre