acoustic foam

vegas · Post by **vegas** » Fri Feb 25, 2005 7:34 am

Hello
I want to order 2" acoustic foam for my bedroom studio 10'x12' and i would like to find out the best location for it .Do you guys have any good tips for placement without using expensive meters?

just keep in mind this is only hobby studio and i want to improve my mixes.
i know that i never be able to master like a pro i my bedroom but i was wonderig what i could to just to make it better. Acoustic foam is pretty affordable and if can use it that would be awesome.
What about foam bass absorbers? should i use them?

I came across this tip for acoustic foam:

When treating the front and side walls, try using a mirror to ascertain where reflections are coming from. Simply have a friend move a mirror around the walls and ceiling while you are sitting at the mix position. Anywhere you can see your studio monitors in the reflection is a likely surface to treat with an Studio foam panel
what do you think?

thanks for reading and all your help

AVare · Post by **AVare** » Fri Feb 25, 2005 10:01 am

I came across this tip for acoustic foam:

When treating the front and side walls, try using a mirror to ascertain where reflections are coming from. Simply have a friend move a mirror around the walls and ceiling while you are sitting at the mix position. Anywhere you can see your studio monitors in the reflection is a likely surface to treat with an Studio foam panel
what do you think?

That "tip" is 100% right. If you have enough foam, go an extra 4 - 6 " past the reflection points.

Andre

vegas · Post by **vegas** » Fri Feb 25, 2005 10:59 am

thanks for your replay
also would like to know if I have to move my desk or just leave it the way it is? I would preferred have my set up as is on my pic.

AVare · Post by **AVare** » Sat Feb 26, 2005 12:29 am

vegas wrote:thanks for your replay
also would like to know if I have to move my desk or just leave it the way it is? I would preferred have my set up as is on my pic.

I hope you are joling witht he question. You wrote the room is 10 x 12 but your drawing is obvsiouly not to scale, so is the desk cenetred or not in the room?

Andre

vegas · Post by **vegas** » Sat Feb 26, 2005 12:39 am

Andre
hehe

i know picture is not the best (just raw pic)
but my desk is in the middle of that wall

Do you think that i should move it?

knightfly · Post by **knightfly** » Mon Feb 28, 2005 7:44 am

If your room is that close to square, it's not critical that the long dimension is the direction you face; here's a pic that sort of identifies what you need in ANY small room, basically you will need absorption behind your speakers to help SBIR and smooth out speaker response, absorption at first reflection points, and MORE absorption behind you. If you hang some of that foam spaced off the wall over your bed, it will help rear reflections somewhat. Other than that, the desk/speakers/your head need to be centered SIDE TO SIDE, but NOT in any OTHER dimension. Measure the height of the center of your woofer cones, it should NOT be within 5-6" of centered VERTICALLY, nor should your head. Check out these two thread for more -

http://www.johnlsayers.com/phpBB2/viewtopic.php?p=18233

http://www.johnlsayers.com/phpBB2/viewtopic.php?p=18059

HTH... Steve

vegas · Post by **vegas** » Tue Mar 01, 2005 4:58 am

Thanks Steve

what do you think i should do to get BEST possible setup in this room.
how is this set up?