Stupid question - but!!

JohnGardner · Post by **JohnGardner** » Mon Sep 06, 2004 8:10 am

I have read up on building slot resonators and understand the basic principle.

I have downloaded the calculator however,

What I don't understand is what frequency I should aim for ie. what size slats and spacing, when putting the slats up on my inside out wall?

Here's the room with the slat walls showen.

Thanks

JohnG

giles117 · Post by **giles117** » Wed Sep 08, 2004 3:36 am

Really not that deep. Do a quick cal to see what is the narrowest spacing you'd do (most people it's 1/4" or 1/8") and the widest slot spacing. For me that was 3/4"

That will tell you the bottom and top frequencie of absorption by the resonator.

Nothing to fret about.

The main reason I recommended it was to keep the room from being to dead.