Hi Guys,
I've just completed one of my doors but unfortunately I have cut it a little too thin. There is a gap on the one side of around 6 to 8 mm. Do I need to start again or can I sort this out with thicker door wood stops?
Many thanks
Door cut too small
-
thedeadzeds
- Posts: 28
- Joined: Sun Dec 09, 2012 10:50 am
- Location: SOUTH WALES UK
-
stevev
- Senior Member
- Posts: 307
- Joined: Wed Jul 15, 2009 11:16 pm
- Location: Trentham,Vic, Australia
- Contact:
Re: Door cut too small
I think you'll need to post a pic of that one to get some advice. The description is a bit vague 
quick, cheap or good....pick any two.