Resilient Bars

Hi Hope someone can help! I am currently looking at the option of resilient channels/bars to a wall/ceiling configuration. The studio will be based in London, England. Its going to be housed within a structure comprising of single breeze-block walls but there is only a corrugated roof so a new roof & ceiling will need to be constructed from scratch. I have looked on a number of sites regarding the installation of resilient bars on walls however the sites I have seen do not advice on configuring the remaining walls after the initial wall has been prepared. I understand that there must be a gap of between 5-10mm around the perimeter of the wall for caulking though any advice for the preparation of the remaining walls would be appreciated. Would I be right to assume that the walls have to be layered with all bars or can one wall be completed at a time until you get to the resilient bar fixing? Any advice would be appreciated Many Thanks Volectron

Please read the forum RULES (stickies) that can be found at this link: viewforum.php?f=17 Then make certain that this is reviewed: viewtopic.php?f=2&t=3231 Please correct your initial post to conform with these rules and guidelines. Many here will not only NOT help while waiting in respect for owners and other better qualified persons to proceed, but will simply ignore these type of posts completely. You may want to immediately ask "what is it that I have missed". Most often it is as simple as including your geographical location in your profile. It might be that you have not included your budget! Trust me in that the more you know the better others can help you and that the answer to that question is in the forum rules linked page. Until then, good luck,