If I want to convert my garage from it's existing in-wall wiring to surface conduit wiring it it OK to disconnect from service pannel and outlets / light switches / etc. and seal in the old boxes.
Just cut off the wire and/or cap them off? Since the wire is not live I am not sure if this would be a problem or against code.
I know an unused live wire or splice should never be sealed in the wall without service access (ie plate).
Convert in-wall wiring to surface conduit wiring.
Originally posted at johnlsayers.com, topic 15869.
why would you do this? unless you're building out the walls for more isolation and in which case you're likely pulling off the old drywall and beefing up etc before putting on a new layer. that said, check with your local building inspector on the options.
disconnect from the panel entirely so it cant be turned on
... as Glenn said: Check your local building code to find out what is required in your area. Don't put too much trust into anonymous "advice", from unknown people in unknown locations, that you find on the internet when it comes to safety and regulations. You might be fine with just disconnecting the wiring at both ends, and you might not. Check with your local qualified experts.
- Stuart -
I am going to have an electrician into the house to deal with some kitchen problems. The whole house is ungrounded (as are most older homes), and as far as I know, so is the large room in the basement I'm going to use for a studio.
[MODERATOR COMMENT: PLAGIARISM SPAMMER: PLAGIARIZED FROM HERE: viewtopic.php?f=16&t=11299&p=80840&hilit=kitchen+problems+ungrounded+older+basement#p80840": SOON TO BE BLOCKED, BANNED AND DELETED...]