Substantial posts by malfunction, who started the thread, and by the forum’s most active contributors. 8 of 14 posts are listed.
Page 1
malfunction, 13 October 2008Hi, So I'm getting somewhere with my construction finally!!! Three years of reading, searching and studying and now the control room is almost finished. A little…
malfunction, 13 October 2008Here are pictures of the first stage of the build. You can see how the room was in the beginning. Then the floor and walls started forming... Image not preserved: 1.jpg…
malfunction, 13 October 2008Heres the second set of photos. I'm missing some photos so theres a big gap in time here. I'll try and locate the misiing photos so I can post them as well. Image not…
malfunction, 14 October 2008Hi John! Thank you very much. Very nice to hear from you and hope you are feeling better. I realised that I didn't post the original design at all so it could be hard to…
malfunction, 20 October 2008Do you guys have an oppinion on this one? All the meters read that the same volume is going out to left and right and the monitors both are setup the same way(no cuts or…
malfunction, 27 October 2008So some progress again. Here are the latest pictures. I built 2 racks for my equipment and covered the monitor soffit with the same fabric that I have on the walls. Next…
malfunction, 28 October 2008The genelecs can be used on their sides but the HF waveguides must be rotated 90degrees for them to work properly. The reason I mounted the monitors sideways is because…
malfunction, 11 January 2009Hi y'all! It's been a very busy winter for me and I really haven't had time to post here due to the studio construction(I'm building everything alone...). Anyways, I had…