Studio Ready! Finishing touches!

Ok guys, thanks to a lot of articles i read on this very forum and some questions answered by you, my rehearsal studio is nearly ready! i attached a bunch of pics so i'd appreciate suggestions! the sound is pretty good, as is the isolation, but theres a bit of sound "leakage" (???) through the door, which was expected, as all i done was use 2 regular doors and seal it with some rubber about the acousticts, there's a bit of feedback on the mics, and they're gone once i cut high frequencies on my mixer, so i suppose i need some high-freq absorbers?? the panels you see hanging there are all rockwool and from what i read (Ethans articles, i think), to absorb higher frequencies, i'd need the so-called 703 rigid fiberglass panels and the thinner they are, the higher they'll absorb, but i cant find it here in Brazil :( any suggestions as to what i should do about those high-frequencies? and last, but not least, i dont know if the pictures are good enough in this regard, but what kind of positioning would you guys suggest for the amps, drums and speakers in the room? thanks a lot guys! PS - For some reason, the comments dont seem to stick with the pics :( i'll try to describe them from top to bottom: Pic 1 - Doors from the outside Pic 2 - As much as i could get in a picture of the whole room Pic 3 - Guitar amps. Are they ok placed like this? one right beside the other? Pic 4 - The "drum-wall" with the absorbing panels Pic 5 - The oposing wall to the drums (the door is right on the right side of this picture) Pic 6 - The whole drumkit with the panels

on with the pics 8) 1 - "drum and bass" :P this pic was taken from the door 2 - speaker 1: bass amp on the right and guitar amp on the left 3 - speaker 2: guitar amp on the right, window and door (duh) on the right. Pic taken from the drums 4 - the door and window wall 5 - i dont know what this is called :( this is there the door closes shut on the floor. my picture sucks, but if u look closely, you'll see a small rubber yellow thingie right outside the wood. this goes all along the door, suposedly to seal it 6 - doors from the inside

should this really be at studio design??

pedrolima wrote:

should this really be at studio design??

Pretty much when the studios finish this is the place people write about it.