Page 1 of 1
insulation
Posted: Tue Nov 30, 2004 6:34 am
by floatious
im using roxul afb,3in. insulation for 2x4 framing, my studs are 16 in. from the center of each stud( 15 in. between studs) . therefore, when i put in the 16 inch wide insulation, i have to stuff about an inch in, is this good or should i cut the insulation?
insulation
Posted: Tue Nov 30, 2004 10:19 pm
by floatious
if i have to cut the insulation should i just tear the sides off or is there a better way for a cleaner cut. please help.
Posted: Wed Dec 01, 2004 2:41 am
by cfuehrer
You might want to post this question in the Studio Construction forum. This forum is more for electronics, electrical and facility wiring so it might not get seen by the right people to answer it.
Re: insulation
Posted: Wed Dec 01, 2004 8:18 am
by gdgross
floatious wrote:if i have to cut the insulation should i just tear the sides off or is there a better way for a cleaner cut. please help.
I just used some heavy duty scissors to do the job.