John Sayers' Recording Studio Design Forum Archive

Hello

I would like to get some expert advice on the use of motion sensor wall lighting switches for use in a control room. Is there any “negative” to using them?

Thanks in advance!

As long as they don't cause any electrical interference as they switch on or off, or during operation, then they should be fine.


- Stuart -

Soundman2020 wrote:As long as they don't cause any electrical interference as they switch on or off, or during operation, then they should be fine.


- Stuart -

Thanks! All control room lighting is on a separate circuit from room’s breaker. I think I’ll try it!

I bought some LED pot lights today. The instructions said "not compatible with occupancy sensors"

I thought I'd throw that out there as a "heads up"

scotth wrote:I bought some LED pot lights today. The instructions said "not compatible with occupancy sensors"

I thought I'd throw that out there as a "heads up"

Thanks!! I’ll definite check into that.