Motion sensor light switches??

What is three phase electrics? how do I wire a patchbay? ask all your techo questions here.

Moderator: Aaronw

Armando
Posts: 30
Joined: Tue Jun 22, 2004 12:27 pm
Location: Parrish, FL USA

Motion sensor light switches??

Post by Armando »

Hello

I would like to get some expert advice on the use of motion sensor wall lighting switches for use in a control room. Is there any “negative” to using them?

Thanks in advance!
Soundman2020
Site Admin
Posts: 11938
Joined: Thu Aug 21, 2008 10:17 am
Location: Santiago, Chile
Contact:

Re: Motion sensor light switches??

Post by Soundman2020 »

As long as they don't cause any electrical interference as they switch on or off, or during operation, then they should be fine.


- Stuart -
Armando
Posts: 30
Joined: Tue Jun 22, 2004 12:27 pm
Location: Parrish, FL USA

Re: Motion sensor light switches??

Post by Armando »

Soundman2020 wrote:As long as they don't cause any electrical interference as they switch on or off, or during operation, then they should be fine.


- Stuart -
Thanks! All control room lighting is on a separate circuit from room’s breaker. I think I’ll try it!
scotth
Posts: 27
Joined: Wed Nov 23, 2016 1:11 am
Location: Morden, MB Canada

Re: Motion sensor light switches??

Post by scotth »

I bought some LED pot lights today. The instructions said "not compatible with occupancy sensors"

I thought I'd throw that out there as a "heads up"
Armando
Posts: 30
Joined: Tue Jun 22, 2004 12:27 pm
Location: Parrish, FL USA

Re: Motion sensor light switches??

Post by Armando »

scotth wrote:I bought some LED pot lights today. The instructions said "not compatible with occupancy sensors"

I thought I'd throw that out there as a "heads up"
Thanks!! I’ll definite check into that.
Post Reply