Sub 40hz absorber
Posted: Mon Sep 05, 2011 2:51 pm
This is what I'm putting on the rear wall of my control room. It is an absorber outlined in Philip Newell's book, he says that it will absorb below 40hz.
We start out with a standard stud wall with rockwool insulation.
Next we have two layers of 5/8" drywall with roofing felt (he uses what he calls deadsheet) sandwiched in between.
Then another stud frame wall.
The next layer is a layer of roofing felt sandwiched between 2" of rockwool
Next we have hangers parallel to the wall.
Here is a close up of the hanger. Rockwool on roofing felt on soundboard on rockwool.
Here we have angled hangers.
Then a frame with fabric covering
We start out with a standard stud wall with rockwool insulation.
Next we have two layers of 5/8" drywall with roofing felt (he uses what he calls deadsheet) sandwiched in between.
Then another stud frame wall.
The next layer is a layer of roofing felt sandwiched between 2" of rockwool
Next we have hangers parallel to the wall.
Here is a close up of the hanger. Rockwool on roofing felt on soundboard on rockwool.
Here we have angled hangers.
Then a frame with fabric covering
