Page 1 of 1
DIY monitors
Posted: Sat Jul 23, 2011 7:13 am
by shanesix
Can any of the speaker experts give me some input ?
Thanks.
I have attached the response charts of an enclosure I calculated using win ISD.
Can you tell me if this range is suitable enough for mid field monitors?
Re: DIY monitors
Posted: Sat Jul 23, 2011 8:25 am
by Soundman2020
Without knowing what the vertical divisions are, it is hard to say, but in any event that speaker would not be much use in a studio unless it is associated with a subwoofer and a crossover that can match the roll-off. Plus, the graph only shows response up to 1K! What about the other half of the spectrum?
On the other hand, reality rarely matches software prediction, and a huge amount of the response of the speaker as a whole depends on the drivers you put in it, how well they are matched to the enclosure, and the quality of electronics that provides the power for the whole thing.