r
-
- Confused, but not senile yet
- Posts: 2336
- Joined: Thu Feb 05, 2004 1:56 pm
- Location: Hanilton, Ontario, Canada
Re: room orientation
Welcome to JLS RSD!
The reason for recommending shooting down the long axis is that with the size of rooms discussed here, the low end would vary more widely with amy given amount of movement, and to maintain rear reflections as long (time) as possible, teh longer dimension is better. As rooms are designed larger, these constraints become insignificant.
Andre
The reason for recommending shooting down the long axis is that with the size of rooms discussed here, the low end would vary more widely with amy given amount of movement, and to maintain rear reflections as long (time) as possible, teh longer dimension is better. As rooms are designed larger, these constraints become insignificant.
Andre
Good studio building is 90% design and 10% construction
-
- Senior Member
- Posts: 1063
- Joined: Fri Feb 21, 2003 3:50 am
- Location: New Milford, CT, USA
- Contact:
Re: room orientation
Those rooms are probably larger than what you have available.studious wrote:i note that many of the control rooms i have worked in at major studios have been oriented such that the distance from left to right is greater than the distance from front to back.
The idea to have the room wider rather than longer is an "audiophile" concept that sort of makes sense in an unsophisticated way. When the room is wide, reflections from the farther side walls are softer and later. So that orientation improves imaging at the expense of bass response. But side-wall reflections are mainly a mid/high frequency issue, so they're very easy to treat. Versus bass problems that require much larger and thicker absorbers, and many more of them.
You can see graphs that compare the LF response directly for both orientations in Figure 3 of this article:
How to set up a room
--Ethan
-
- Confused, but not senile yet
- Posts: 2336
- Joined: Thu Feb 05, 2004 1:56 pm
- Location: Hanilton, Ontario, Canada
Re: room orientation
With that 13' dimension, it is too small for me to recommend usiing that as the length for the speaker setup. Look at some form of shell ala Waterland to give symmetrical high frequency symmetrical early reflection acoustics around the monitors.
Andre
Andre
Good studio building is 90% design and 10% construction
-
- Confused, but not senile yet
- Posts: 2336
- Joined: Thu Feb 05, 2004 1:56 pm
- Location: Hanilton, Ontario, Canada
Re: room orientation
Yes, and overlooked that when writing my previous post. More detail, a picture perhaps? would help immensely.studious wrote:in saying the room would be too short [small?], are you taking into account the fact that there is really no actual solid back wall at 13'?
The shell is more like the front wall of a control room. It provides the symmetry for the monitor environment. I tried to find a picture on the web but had no luck.could you explain a little more about the need for a shell, and its benefits?
Andre
Last edited by AVare on Wed Mar 24, 2010 2:01 am, edited 1 time in total.
Good studio building is 90% design and 10% construction
-
- Senior Member
- Posts: 1063
- Joined: Fri Feb 21, 2003 3:50 am
- Location: New Milford, CT, USA
- Contact:
Re: room orientation
Can you post a photo? A back wall that's partially missing means the room is actually longer for part of it. Regardless, the only way to know what you really have is to measure the LF response at high resolution using appropriate software.studious wrote:1. the "back wall" of the room is not really a solid wall. the room is partially open to the rest of the house, with a partial wall extending about 14' from right of the room toward the middle of the room.
--Ethan
-
- Site Admin
- Posts: 11938
- Joined: Thu Aug 21, 2008 10:17 am
- Location: Santiago, Chile
- Contact:
Re: r
The original poster is gone, Ethan: He scuttled off in a pathetic kiddie huff (after first deleting all of his own posts on the entire forum) when nobody wanted to join his Genelec fan club on another thread.
Go figure!
- Stuart -
Go figure!

- Stuart -
-
- Posts: 14
- Joined: Wed Mar 17, 2010 5:08 pm
- Location: United States
Re: r
Soundman2020 wrote:The original poster is gone, Ethan: He scuttled off in a pathetic kiddie huff (after first deleting all of his own posts on the entire forum) when nobody wanted to join his Genelec fan club on another thread.
Go figure!![]()
- Stuart -
nobody scuttled anywhere. you're acting like an ass, though, by the way. is your main problem obsessive / compulsive disorder or erectile dysfunction, or both?
this thread had no response for days, i had already thanked the nice people that were helpful, and it is not a good idea to leave photographs like that posted for no reason.
anyhow, you really should mind your own business, if any.
what are you doing, trolling the forum like a lunatic, for opportunities to bad-mouth me?
if you are an example of a "senior member", then it must be a very lame forum.
-
- Site Admin
- Posts: 11938
- Joined: Thu Aug 21, 2008 10:17 am
- Location: Santiago, Chile
- Contact:
Re: r
Heheh. Like I said: pathetic, petty, childish. Wasn't it you talking about unprofessional responses in the other thread?is your main problem obsessive / compulsive disorder or erectile dysfunction, or both?
Except maybe for the reason that you accepted the forum rules when you signed up here. Did you forget about that? Maybe you should read the rules again...and it is not a good idea to leave photographs like that posted for no reason.
Sorry, but I don't bother replying to web kiddies: I treat them with the contempt they deserve.what are you doing, trolling the forum like a lunatic, for opportunities to bad-mouth me?

if you are an example of a "senior member", then it must be a very lame forum.

-
- Posts: 85
- Joined: Wed Sep 20, 2006 10:14 am
- Location: Amsterdam, The Netherlands
Re: r
You are so much better than us...studious wrote:...then it must be a very lame forum.
Regards,
Edo
Edo