John Sayers' Recording Studio Design Forum Archive

I new here and sorry for my english i speak spanish, I found this site and I have problems to make the instalation for the mixer to the snake cable to the studio ....how you make the instalation whitout brake the insulation in the live studio and the recording?????I can't find any planes about that .....sorry if is dificult to awnser or undertand me ....I do my best, thank yo very much

I believe that if you make holes between your live room and control room and then pass your snake between them (making sure it is not tight) and then seal around the holes tightly will insulation and caulk, it should't break the isolation.

This is just my view and there are a lot more people on this site who have much more experience in these matters.

Hope this was of help
Tom