John Sayers' Recording Studio Design Forum Archive

We should do some REW tests about now!

- Stuart -

Soundman2020 wrote:

We should do some REW tests about now!

- Stuart -

Yes. I will finish up the speaker mounts first and then run some more testing

Some updates. Finishing up the back of the room. Still missing the corner base traps though.

Things are moving along quite nicely. Front wall nearly finished

Any updates?

Greg

Gregwor wrote:Any updates?

Greg

Hi Greg

I have been occupied with other stuff the last few weeks unfortunately. Back in business now though
I have this week finished the last part of the ceiling at the front. Now Im currently working on the first part of the cloud.
Will most likely finished it this week. I will try to post as I move along

Hi!

Looking good! Nice to see there's still progress being made.

Keep those pics coming if you can!

Dan

Waka wrote:Hi!

Looking good! Nice to see there's still progress being made.

Keep those pics coming if you can!

Dan

Hi Dan

Thanks for taking an interest
Still working on the clouds. Here is som updated pics The store was out of two lights so I had to order more. Put a lid on in the mean time:)

Hi
New update:
Almost finished with the first front cloud. A few adjustments still needed. Also waiting for the last two lights that’s coming in the mail. I will hopefully finish this one up in the next few days and start on the last back cloud.

Looking really good Bjorn!

Can I ask the rationale behind your "slotted" side walls, are they evenly spaced/sized lengths of timber? I assume it's some kind of non-numeric scattering?

Dan

Waka wrote:Looking really good Bjorn!

Can I ask the rationale behind your "slotted" side walls, are they evenly spaced/sized lengths of timber? I assume it's some kind of non-numeric scattering?

Dan

Thanks Dan!

As shown in previous posts the slot side walls are spaced timber. See the picture below. When it comes to the rational thinking and calculations we need to ask Stuart if he can clarify a bit. I hired some hours from him to design the room tuning after the last measures I did. You can read about it in the earlier posts.
http://johnlsayers.com/phpBB2/viewtopic ... 3&start=45. Im not sure if his active on this forum anymore though.

Waka wrote: I assume it's some kind of non-numeric scattering?
Dan

Hi again Dan
I see now on other posts that Stuart has left the building and will most likely not return anytime soon. I have attached some measurements of my slot wall and some race trace. Hope that can bring some clarification to you question.

- Bjorn -

New Updates. Missing lights installed. New computer build and the last back cloud mounted. Corner base trapps to go.
Computer mount:
Check out this badass heat sink for the computer processor. Very silent .

Do you have any mdat to share to show us the acoustic changes with each new device you installed?

Looks beautiful!

Greg

Gregwor wrote:Do you have any mdat to share to show us the acoustic changes with each new device you installed?

Looks beautiful!

Greg

Thanks Greg, really appreciate it .
I dont have an mdat for each new change. I was waiting with the next measurement while I was finishing up the cloud construction.

I will do some measurement now before I install the corner base traps and share with you guys

Bjorn