Page 3 of 3
Re: [rename] Lilith design Phase ( L Shape )
Posted: Thu Jul 23, 2009 12:29 pm
by lilith_envy
I'm using hi span or Smart span manufactured truss.
Can do 4.2m with 16mm plasterboard easily.
Same as in my control room. 4m spam with no extra bits!
Re: [rename] Lilith design Phase ( L Shape )
Posted: Thu Jul 23, 2009 12:33 pm
by John Sayers
javier - Deanne isn't building an inside out ceiling and its a 3.2m - 4m span.
deanne - you don't need to cut the rafters to exact shape - so long as they are held down they'll hold the plaster which will be the seal. Maybe a few multinail units would help
http://www.multinail.com.au/default.asp?id=1,3,7,119
Re: [rename] Lilith design Phase ( L Shape )
Posted: Thu Jul 23, 2009 1:28 pm
by xSpace
lilith_envy wrote:This was my 1st idea as I'm thinking about have exposed beams to add a bit of character. But what happens to the right were the wall extends further.
Run a band of the same height material all around the outside edges of the top plate. This will close up the open ends of the joists and allow the exposed beams you want plus it will make a place for the sheet rock to be nailed into.
Re: [rename] Lilith design Phase ( L Shape )
Posted: Thu Jul 23, 2009 7:14 pm
by John Sayers
xSpace wrote:lilith_envy wrote:This was my 1st idea as I'm thinking about have exposed beams to add a bit of character. But what happens to the right were the wall extends further.
Run a band of the same height material all around the outside edges of the top plate. This will close up the open ends of the joists and allow the exposed beams you want plus it will make a place for the sheet rock to be nailed into.
yep - or do what javier is doing and build the inside out ceiling but expose the beams.
Re: [rename] Lilith design Phase ( L Shape )
Posted: Fri Jul 24, 2009 8:53 am
by lilith_envy
Yes, thanks guys.
will see how I go with the control room ceiling and if I'm still sane at the end.
The ceiling truss is laminated and not sure if it will get the desire look.