John Sayers' Recording Studio Design Forum Archive

Nearly there people

One little question: Should I place absorbent panels underneath the table under the edge nearest to the wall?

Thanks

Nobody is going to even comment on my desk?

Should I place absorbent panels underneath the table under the edge nearest to the wall?

I would, yes.




- Stuart -

Looks good ,big ,empty now you just need a mixer to put on it

Can't tell from the photo but is the surface angled? You might incur some reflection problems if not!

@Stuart

Thanks Stuart, I thought so, but wanted to check on you

@BriHar

The surface is not angled so far, but I can angle it easily. I guess Should I angle it towards the speakers or towards my sitting position?
The surface is prepared to receive Euphonix MC Artists series controllers

Cheers

Usually you'll want to angle it so its higher near the far edge. In your case it's probably best to wait however because you'll have to take the angling of the controller surface in conjunction with the percentage of the desk surface which they will cover into consideration as well as their orientation in regrd to the monitors - basically we're talking first reflections here.

I see what you mean. I'll wait to finish the panels underneath
Thanks

Could you post some pictures so we can see the finished CR?

Or maybe you have a website/page?

Kind Regards,
Marko Z.