Side by side doors
-
- Posts: 104
- Joined: Tue Jul 27, 2004 4:14 am
- Location: Montana, USA
Side by side doors
Does anyone have any ideas about soundproofing side by side doors?
-
- Senior Member
- Posts: 6976
- Joined: Sun Mar 16, 2003 11:11 am
- Location: West Coast, USA
-
- Posts: 104
- Joined: Tue Jul 27, 2004 4:14 am
- Location: Montana, USA
Side by side doors
Right...like French doors. I understand the basics of "soundproof" doors, but don't know how the juncture of the two doors would be treated. Do you know what I mean? Magnetic strip, neoprene, ????...I can't envision it, although I got a quote for a pair with STC of 50, by Ambico for around $2500, a bit rich for my blood! In line with that, what if I put in 2 sets of sliding glass doors? What is the best STC I could hope for?
Thanks.
Thanks.
-
- Posts: 96
- Joined: Fri Jul 09, 2004 3:57 am
It depends on the hardware. The most typical double doors has a strip called a transom that is attached to the door that must be opened first (or second depending which side it is on). The door that must be opened second usually has sliding surface bolts floor and ceiling.
The more expensive hardware has a vertical rod, either internal or external, that runs the height of the door and inserts into the head and/or sill. This is more expensive but allows either door to be opened first.
The former is easier to seal since you have the surface of the transom to seal against.
The more expensive hardware has a vertical rod, either internal or external, that runs the height of the door and inserts into the head and/or sill. This is more expensive but allows either door to be opened first.
The former is easier to seal since you have the surface of the transom to seal against.
-
- Posts: 104
- Joined: Tue Jul 27, 2004 4:14 am
- Location: Montana, USA
Side by side doors
Thanks, Innova. It's looking as though this set of doors will cost anywhere from $1500 to $2500. Yikes.
I'm also trying to solve the control room to piano room door problem. One thought was to use a sidelight and one door for a 6 foot wide space.
Double them up , of course. My thinking was that the sidelight would provide better insulation than part of a sliding door, but I don't know.
I'm also trying to solve the control room to piano room door problem. One thought was to use a sidelight and one door for a 6 foot wide space.
Double them up , of course. My thinking was that the sidelight would provide better insulation than part of a sliding door, but I don't know.
-
- Posts: 96
- Joined: Fri Jul 09, 2004 3:57 am
if the reason that you are thinking about double doors is to be able to get a piano in and out, which I am presuming will not be very often at all, then there is another choice, and that is a removable center stile. Sure it takes a few minutes to unbolt and remove it, but it is an infrequent need. But a simpler approach would be to have only one normally openable side, the other having sliding surface bolts top and bottom, and transoms on both doors to get extra contact surface for rubber seals.